Head blueLogoText.gif NCF HelpWiki
Help | StartPage

Router Configuration

From Support
Revision as of 20:39, 25 December 2014 by Fn352 (talk | contribs) (General router configuration information: wikilinking)
Jump to: navigation, search

This page deals with configuring a wifi router to work with a DSL modem.

Router Configuration

When a separate router is used with your NCF modem, the typical setup is to put the modem into Bridge mode and have the router do the user authentication. The name of that authentication setting is called "PPPoE" (Point-to-Point Protocol over Ethernet).

You should be able to configure your router by simply connecting the unit to your computer with an ethernet cable and accessing the built-in configuration page though your web browser. The address for the user interface, to be entered in your browser's location bar, is often written on the bottom of the unit, or in the router's user manual.

General router configuration information

Once you can edit the router's interface enter:

  1. Under "Connection type" (or similar term) Select "PPPoE"
  2. Under "Account Name", enter in your NCF ID (same format as ab123@ncf.ca)
  3. Under "Password", enter your DSL password. Enter it in again under "Verify Password" if required
  4. Under "Service Name", check your router manual or leave it blank.

How to configure some specific router models

See also