Head blueLogoText.gif NCF HelpWiki
Help | StartPage

Difference between revisions of "VOIP"

From Support
Jump to navigation Jump to search
(→‎Accessing Telnet: 192.168.1.1)
Line 14: Line 14:
==Accessing Telnet==
==Accessing Telnet==
===Linux===
===Linux===
On Linux operating systems you can access telnet by opening a terminal and typing in "telnet" at the prompt.
On Linux operating systems you can access telnet by opening a terminal and typing in "telnet 192.168.1.1" at the prompt.


===Windows===
===Windows===

Revision as of 14:44, 2 November 2012

VOIP means Voice Over Internet Protocol, where your telephone service is provided via the internet.

Using VOIP with a TP-Link modem

If you are using VOIP with a TP-Link modem you may experience problems such as voice being received but not transmitted after a connection is established. This may be addressed with a command line setting change in the modem to enable this via telnet to 192.168.1.1.

ip nat service sip sw off

If the command is successful the following line will be returned:

nat sip v2 switch off

Note that this configuration change cannot be saved and so when the modem is rebooted or powered off the command will have to be re-run.

Accessing Telnet

Linux

On Linux operating systems you can access telnet by opening a terminal and typing in "telnet 192.168.1.1" at the prompt.

Windows

On Windows XP and Vista operating systems telnet can be accesses by opening "run" and the "cmd" command and entering telnet.

In Windows 7 and 8 you can bring up the command line by entering "cmd" in the search bar.

In any version of Windows you can also run telnet by installing and using the PuTTY free software application.

For complete Windows instructions see this TP-Link page.