Router Configuration
Revision as of 12:57, 29 October 2012 by Fn352 (talk | contribs) (→General router configuration information: correction)
This page deals with configuring a wifi router to work with a DSL modem.
Router Configuration
When a separate router is used with your NCF modem, the typical setup is to put the modem into Bridge mode and have the router do the user authentication. The name of that authentication setting is called "PPPoE."
You should be able to configure your router by simply connecting the unit to your computer with an ethernet cable, and accessing the built-in configuration page though your web browser. The address for the user interface, to be entered in your browser's location bar, is often written on the bottom of the unit, or in the router's user manual.
General router configuration information
Once you can edit the router's interface enter:
- Under "Connection type" (or similar term) Select "PPPoE"
- Under "Account Name", enter in your NCF ID (same format as ab123@ncf.ca)
- Under "Password", enter your DSL password. Enter it in again under "Verify Password" if required
- Under "Service Name", check your router manual or leave it blank.