SpeedTouch Configuration
Jump to navigation
Jump to search
Configuring the Modem/Router
- Plug in modem (including power and ethernet) then turn on modem
- Open web browser and type http://speedtouch.lan in to the address bar. Hit enter
- Click Speedtouch from the menu on the left
- Click Setup in the pick a task section at the bottom of the page. This will cause a popup to come up on your screen saying welcome to speedtouch easy setup
- Click Next
- Select Router from the menu in the Service Selection window
- Click Next
- Use the drop down menu to select 0.35 in the VPI/VCI section of the Routed Internet Connections
- Confirm that PPPoE is selected
- Click Next
- In the Internet Account Settings window, enter the DSL username as issued by NCF (e.g. aa000@ncf.ca)
- Enter the DSL password twice. This password will start with the letters ncf and is not the normal password for your account
- In the Access Controls window leave the username as Administrator and enter the DSL Password in the password fields twice
- Click Next
- You will now see a Confirmation Page. Click Start
- You will now have to wait as the SpeedTouch configures itself. You will see a window asking you to do so.
- Re-enter the DSL modem username Administrator and the DSL password to confirm
- Click Finish
To disable / enable wireless functions
- Open web browser and type http://speedtouch.lan in to the address bar. Hit enter
- Enter the username Administrator and the DSL password
- Click on Home Network in the left column
- Click on Wlan: Speedtouch...
- Wireless Access Point menu will appear. At the top right, click Configure
- In the Configuration section, remove the checkmark beside Interface Enabled to disable wireless, or add the checkmark to enable it
- Click Apply
Enabling the speedtouch firewall
- Open web browser and type http://speedtouch.lan in to the address bar. Hit enter.
- Enter the username Administrator and the DSL password
- Click on Toolbox in the left column
- Click on Firewall
- Click on Configure in the top right
- Menu called security settings will appear. Click the button called Standard
- Click Apply. This will redisplay your settings so that you can confirm.
Setting up the NRC time server
- Click on Speedtouch on the left column
- Click on Configuration
- Click on Configure in the top right
- In the section called Time Configuration check the auto-configuration checkbox
- Change the time zone to -5 Eastern Time
- Check Summertime if it is currently Daylights Savings Time
- In the box called Time Server 1 enter time.nrc.ca
- Click Apply