Difference between revisions of "SmartRG SR506n"
m |
m |
||
| Line 3: | Line 3: | ||
'''Updated: 2019-03-26''' | '''Updated: 2019-03-26''' | ||
'''Recommended Firmware Version: 2.6. | '''Recommended Firmware Version: 2.6.2.2''' | ||
The SmartRG SR506n modem router supports both ADSL and VDSL, and switches automatically to match the line it is connected to. | The SmartRG SR506n modem router supports both ADSL and VDSL, and switches automatically to match the line it is connected to. | ||
Revision as of 11:54, 17 July 2019
Sold from Aug 2018 to July 2021
- Home
- Configuration from File
- Routed Configuration
- Bridge Configuration
- Firmware Check and Update
- Changing WiFi Channels on SmartRG modems
- Changing WiFi Name or Password on SmartRG modems
- Changing DNS Settings on SmartRG Modems
- Port Forwarding
- About your SmartRG SR506n
- SmartRG - Manual
- SmartRG - Data Sheet
- Highspeed Tips - SR505n Emulator (differs slightly)
Preparation
Updated: 2019-03-26
Recommended Firmware Version: 2.6.2.2
The SmartRG SR506n modem router supports both ADSL and VDSL, and switches automatically to match the line it is connected to.
- Note: Fees for changing plans apply, see our DSL Rates.
Before you start configuring the modem:
- Firmware Check: Check that your firmware is up to date or update to the recommended version. If you have a different firmware version, the screenshots and instructions might not match exactly. Contact support@ncf.ca if you need assistance.
- Factory Settings: The instructions are for configuring the modem new out of the box or after it is been reset to factory settings. If the modem is not new, we recommend resetting it by holding down the reset button with a paper clip for about 10 seconds.
- We recommend these settings for most NCF members. To learn more about what the settings do and more advanced settings, consult the manual.
- Ethernet Connection: Consult the About your SmartRG SR506n modem instruction sheet to learn how to connect the modem. We recommend configuring the modem using a computer connected by an ethernet cable, as opposed to over a wireless connection.
Configuration
Before the modem will connect to the Internet, it needs to be configured with your NCF account information. You can follow our instructions to configure the modem yourself, or contact support@ncf.ca if you would like to bring your modem to our office to be configured.
Methods
If you have access to email, we can send you a file to automatically configure the modem with your NCF account and our recommended settings, which is much easier than going through all the steps manually. You can request a config file from support@ncf.ca then follow our instructions to configure your modem with a config file.
Alternatively, you can follow the instructions below to configure the modem without a config file.
Modes of Operation
- Routed - Functions as both a modem and WiFi router, which is recommended for most members. Another router can be added to extend the network, but each network must use a different subnet.
- Bridge - (Advanced) Functions only as a modem, so another device is required to make the PPPoE connection. Recommended for advanced members using a separate router.
Images
SmartRG SR506n - Front
SmartRG SR506n - Back
SmartRG SR506n - bottom
SmartRG SR506n - Left Side
SmartRG SR506n - Angled
See Also
- Modem Configuration - Instructions for all NCF modems
- About SmartRG modem lights
- Changing WiFi Channels on SmartRG modems
- Dynamic DNS
- Port forwarding with the SmartRG SR505N